Generic placeholder image

Current Applied Polymer Science

Author(s): Wanda Jones, Bedanga Sapkota, Brian Simpson, Tarig A. Hassan, Shaik Jeelani and Vijaya Rangari*

DOI: 10.2174/2452271605666220114113214

DownloadDownload PDF Flyer Cite As
Fabrication and Characterization of Carbon Nanofibers Coated Expandable Thermoplastic Microspheres-Based Polymer Composites

Page: [117 - 124] Pages: 8

  • * (Excluding Mailing and Handling)

Abstract

Background: Thermoplastic expandable microspheres (TEMs) are spherical particles that consist of polymer shell encapsulating a low boiling point liquid hydrocarbon that acts as the blowing agent. When TEMs are heated at 80-190 °C, the polymer shell softens, and the hydrocarbon gasifies, causing the microspheres to expand, leading to an increase in volume and decrease in density. TEMs are used in food packaging, elastomeric cool roof coatings, shoe soles, fiber and paper board, and various applications in the automotive industry. It is noted that TEMs are known by their brand name ‘Expancel’, which is also used to refer TEMs in this paper.

Objective: The objective of this work was to develop and characterize forms prepared from TEMs with/without carbon nanofibers (CNFs) coatings to study the effect of CNFs on structural, thermal, and mechanical properties.

Methods: Sonochemical method was used to coat TEMs with various weight percentages (1, 2, and 3%) of CNF. Neat foam (without CNF) and composite foams (TEMs coated with various wt.% of CNF) were prepared by compression molding the TEMs and TEMs-CNF composites powders. Thermal and mechanical properties of the neat and composite foams were investigated.

Results: The mechanical properties of the composite foam were notably improved, which is exhibited by a 54% increase in flexural modulus and a 6% decrease in failure strain with the TEMs-(2 wt.% CNF) composite foam as compared to the neat foam. Improvement in thermal properties of composite foam was demonstrated by a 38% increase in thermal stability at 800ºC with the TEMs-( 1 wt.% CNF) composite foam as compared to the neat foam. However, no change in the glass transition of TEMs was observed with the CNF coating. SEM-based analysis revealed that CNFs were well dispersed throughout the volume of the TEMs matrix, forming a strong interface.

Conclusion: Straightforward sonochemical method successfully triggered efficient coating of TEMs with CNFs, resulting in a strong adhesion interface. The mechanical properties of composite foams increased up to 2% of CNFs coating and then decreased with the higher coating, presumably due to interwoven bundles and aggregation of CNFs, which might have acted as critical flaws to initiate and propagate cracking. Thermal properties of foams increased with the CNFs coating while no change in glass transition temperature was observed due to coating.

Keywords: Carbon nanofibers, sonochemical, thermoplastic expandable microspheres, coating, thermal properties, mechanical properties.

[1]
Stewart JK, Mahfuz H, Carlsson LA. Enhancing mechanical and fracture properties of sandwich composites using nanoparticle reinforcement. J Mater Sci 2010; 45(13): 3490-6.
[http://dx.doi.org/10.1007/s10853-010-4380-0]
[2]
Hou Z, Xia Y, Qu W, Kan C. Preparation and properties of thermoplastic expandable microspheres with P (VDC-AN-MMA) shell by suspension polymerization. Inter J Polymer Mater Polymer Biomater 2015; 64(8): 427-31.
[http://dx.doi.org/10.1080/00914037.2014.958831]
[3]
Gao Y, Zhang N, Zhu L, Hou Z. Preparation and properties of thermoplastic expandable microspheres with P (AN-MMA) shell. Russ J Appl Chem 2017; 90(10): 1634-9.
[http://dx.doi.org/10.1134/S1070427217010123]
[4]
Rohm A. Technical Information for ROHACELL Foam. 2002.
[5]
Inc D. Technical Information for Divinycell Foam. Dab Group 2002.
[6]
Expancel is a lightweight filler and blowing agent all in one. Its high performance opens a world of possibilities. Available from: https://www.nouryon.com/products/expancel-microspheres/
[7]
Andersson H, Griss P, Stemme G. Expandable microspheres-surface immobilization techniques. Sens Actuators B Chem 2002; 84(2-3): 290-5.
[http://dx.doi.org/10.1016/S0925-4005(02)00017-5]
[8]
Lu X, Zhou J, Lu W, Liu Q, Li J. Carbon nanofiber-based composites for the construction of mediator-free biosensors. Biosens Bioelectron 2008; 23(8): 1236-43.
[http://dx.doi.org/10.1016/j.bios.2007.11.006] [PMID: 18083363]
[9]
Tomalino M, Bianchini G. Heat-expandable microspheres for car protection production. Prog Org Coat 1997; 32(1-4): 17-24.
[http://dx.doi.org/10.1016/S0300-9440(97)00080-5]
[10]
Vaikhanski L, Nutt SR. Fiber-reinforced composite foam from expandable PVC microspheres. Compos, Part A Appl Sci Manuf 2003; 34(12): 1245-53.
[http://dx.doi.org/10.1016/S1359-835X(03)00255-0]
[11]
Kim Y-W, Kim S-H, Kim H-D, Park CB. Processing of closed- cell silicon oxycarbide foams from a preceramic polymer. J Mater Sci 2004; 39(18): 5647-52.
[http://dx.doi.org/10.1023/B:JMSC.0000040071.55240.85]
[12]
Aglan H, Shebl S, Morsy M, Calhoun M, Harding H, Ahmad M. Strength and toughness improvement of cement binders using expandable thermoplastic microspheres. Constr Build Mater 2009; 23(8): 2856-61.
[http://dx.doi.org/10.1016/j.conbuildmat.2009.02.031]
[13]
Petrossian G, Hohimer CJ, Ameli A. Highly-loaded thermoplastic polyurethane/lead zirconate titanate composite foams with low permittivity fabricated using expandable microspheres. Polymers (Basel) 2019; 11(2): 280.
[http://dx.doi.org/10.3390/polym11020280] [PMID: 30960264]
[14]
Okolieocha C, Raps D, Subramaniam K, Altstädt V. Microcellular to nanocellular polymer foams: Progress (2004–2015) and future directions–A review. Eur Polym J 2015; 73: 500-19.
[http://dx.doi.org/10.1016/j.eurpolymj.2015.11.001]
[15]
Jiao S, Sun Z, Zhou Y, et al. Surface-coated thermally expandable microspheres with a composite of polydisperse graphene oxide sheets. Chem Asian J 2019; 14(23): 4328-36.
[http://dx.doi.org/10.1002/asia.201901233] [PMID: 31650678]
[16]
Aslani F, Wang L, Zheng M. The effect of carbon nanofibers on fresh and mechanical properties of lightweight engineered cementitious composite using hollow glass microspheres. J Compos Mater 2019; 53(17): 2447-64.
[http://dx.doi.org/10.1177/0021998319827078]
[17]
Wang J, Zhang L, Bao J-B. Supercritical CO2 assisted preparation of open-cell foams of linear low-density polyethylene and linear low-density polyethylene/carbon nanotube composites. Chin J Polym Sci 2016; 34(7): 889-900.
[http://dx.doi.org/10.1007/s10118-016-1806-4]
[18]
Zhou Y, Pervin F, Jeelani S, Mallick P. Improvement in mechanical properties of carbon fabric–epoxy composite using carbon nanofibers. J Mater Process Technol 2008; 198(1-3): 445-53.
[http://dx.doi.org/10.1016/j.jmatprotec.2007.07.028]
[19]
Kabir ME, Saha M. Effect of ultrasound sonication in carbon nanofibers/polyurethane foam composite. Mater Sci Eng A 2007; 459(1-2): 111-6.
[http://dx.doi.org/10.1016/j.msea.2007.01.031]
[20]
Levi BG. Light comes from ultrasonic cavitation in picosecond pulses. Phys Today 1991; 44(11): 17-8.
[http://dx.doi.org/10.1063/1.2810317]
[21]
Sapkota B. Bioinspired materials composed of atomically-thin nanosheets and their assemblies. MSc. Dissertation. Boston, USA: Northeastern University 2019.
[http://dx.doi.org/10.17760/D20321696]
[22]
Wanunu M, Sapkota B. Porous membranes comprising nanosheets and fabrication thereof. US 2019/0039028 A1, 2019.
[23]
Zainuddin S, Mahfuz H, Jeelani S. Enhancing fatigue performance of sandwich composites with nanophased core. J Nanomater 2010; 2010.
[http://dx.doi.org/10.1155/2010/712731]
[24]
Mahfuz H, Uddin MF, Rangari VK, Saha MC, Zainuddin S, Jeelani S. High strain rate response of sandwich composites with nanophased cores. Appl Compos Mater 2005; 12(3-4): 193-211.
[http://dx.doi.org/10.1007/s10443-005-1123-5]
[25]
Mahfuz H, Rangari VK, Islam MS, Jeelani S. Fabrication, synthesis and mechanical characterization of nanoparticles infused polyurethane foams. Compos, Part A Appl Sci Manuf 2004; 35(4): 453-60.
[http://dx.doi.org/10.1016/j.compositesa.2003.10.009]
[26]
Mahfuz H, Islam MS, Rangari VK, Saha MC, Jeelani S. Response of sandwich composites with nanophased cores under flexural loading. Compos, Part B Eng 2004; 35(6-8): 543-50.
[http://dx.doi.org/10.1016/j.compositesb.2003.11.004]
[27]
Rangari VK, Hassan TA, Zhou Y, Mahfuz H, Jeelani S, Prorok BC. Cloisite clay-infused phenolic foam nanocomposites. J Appl Polym Sci 2007; 103(1): 308-14.
[http://dx.doi.org/10.1002/app.25287]
[28]
Rangari VK, Jeelani MI, Zhou Y, Jeelani S. Fabrication and characterization of MWCNT/thermoplastic microsphere nanocomposite foams. Inter J Nanosci 2008; 7(02n03): 161-9.
[29]
Jones WD, Rangari VK, Hassan TA, Jeelani S. Synthesis and characterization of (Fe3O4/MWCNTs)/epoxy nanocomposites. J Appl Polym Sci 2010; 116(5): 2783-92.
[http://dx.doi.org/10.1002/app.31193]
[30]
Bhoyate S, Kahol PK, Mishra SR, Perez F, Gupta RK. Polystyrene activated linear tube carbon nanofiber for durable and high-performance supercapacitors. Surf Coat Tech 2018; 345: 113-22.
[http://dx.doi.org/10.1016/j.surfcoat.2018.04.026]
[31]
Armstrong W, Sapkota B, Mishra S. Silver decorated carbon nanospheres as effective visible light photocatalyst. MRS Online Proceedings Library Archive 2013; p. 1509.
[32]
Wang X, Wang L, He Y, Wu M, Zhou A. The effect of two-dimensional d-Ti3C2 on the mechanical and thermal conductivity properties of thermoplastic polyurethane composites. Polym Compos 2020; 41(1): 350-9.
[http://dx.doi.org/10.1002/pc.25374]
[33]
Verma A, Baurai K, Sanjay M, Siengchin S. Mechanical, microstructural, and thermal characterization insights of pyrolyzed carbon black from waste tires reinforced epoxy nanocomposites for coating application. Polym Compos 2020; 41(1): 338-49.
[http://dx.doi.org/10.1002/pc.25373]
[34]
Mao Q, Yang L, Geng X, Chen L, Zhao H, Zhu H. Interface strain induced hydrophobic facet suppression in cellulose nanocomposite embedded with highly oxidized monolayer graphene oxide. Adv Mater Interfaces 2017; 4(23): 1700995.
[http://dx.doi.org/10.1002/admi.201700995]
[35]
Casal E, Granda M, Bermejo J, Bonhomme J, Menéndez R. Influence of porosity on the apparent interlaminar shear strength of pitch-based unidirectional C–C composites. Carbon 2001; 39(1): 73-82.
[http://dx.doi.org/10.1016/S0008-6223(00)00085-3]
[36]
Li J, Luo R. Study of the mechanical properties of carbon nanofiber reinforced carbon/carbon composites. Compos, Part A Appl Sci Manuf 2008; 39(11): 1700-4.
[http://dx.doi.org/10.1016/j.compositesa.2008.07.009]